Position: DGTQ Multipurpose weight transmitter/indicator for panel mounting, 4 dependent or independent channels for direct reading and diagnostics of each connected load cell. The wide range of available interfaces, makes it easy to integrate the weighing with any automation system. CE-M approvable (OIML R-76 / EN 45501).
FEATURES
Easy to use 5-key waterproof keyboard of the weight transmitter.
Highly efficient red LED display with 6 13-mm digits and 6 LEDs for showing active functions.
Case for panel mounting in Abs according to DIN standard, 96x96x80 mm (lxhxpx).
Perforation 90x88 mm (lxh) for panel mounting of the weight transmitter.
Calibration, Set-Up parameters, configurable from keyboard or from PC with DINI TOOLS Up to 10.000e or multirange 2 x 3000e @ 0,3 μV/d for CE-M approved legal for trade use.
Up to displayable 800.000d with internal resolution up to 3.000.000 points.
Up to 8 signal linearization points with DINITOOLS (3 from keypad).
A/D 24-bit sigma-delta conversion, up to 200 conv./sec. autoselect.
Connectable with up to 16 analogue load cells with 350 Ohm input resistance.
Management of a digitally equalised 4-cell weighing system or management of 4 independent weighing systems.
Master/Slave management (up to 4 Slaves / 1 Master).
From 12 Vdc to 24 Vdc power supply.
FUNCTIONS of the weight transmitter
THROUGH KEYBOARD:
Zeroing Automatic and presettable tare print and/or data transmission ON/Stand- by Weighs totalisation Formulation Net/Gross weight switch Counting Hold Peak kg/Lb conversion.
REMOTABLE FROM EXTERNAL INPUT:
Clearing Automatic tare Print and/or data transmission Selected function command ON/Stand-by.
UNIVERSAL WEIGHT REPEATER:
Connectable to any scale or PC through the RS232 or RS485 serial connection, with software configuration of the input data string.
THROUGH SERIAL LINE:
Reading of the net, gross, and tare weights, microvolts or ADC converter for all the channels Clearing Automatic and presettable tare Scale switch Printing Message display Setting of APW in piece counting Setting of set points of the outputs Simulation of key pressure Reading/Writing of Alibi Memory.
THROUGH PROFIBUS (DGT60PB3GD): Reading of the net, gross, or tare weights Clearing Automatic tare Scale switch Setting of set points of the outputs Reading/Writing of Alibi Memory.
THROUGH 16 bit ANALOGUE OUTPUT (DGT60AN3GD):
Analogue output proportional to the net or gross weight, either positive (in loading) or negative (in unloading).
Weight transmitter I/O SECTION
RS232/C bidirectional port configurable for connection with external units.
RS485 bi-directional port configurable for network connection.
Two 150 mA 48 Vac / 150 mA 60 Vdc (NO) photomosfet outputs which may be configured as direct control or upon weight stability, with programmable weight thresholds (disable and enable thresholds).
2 configurable optoisolator photocoupler inputs: 12÷24 Vdc, 5 mA min - 20 mA max.
MODBUS serial protocol (DGT4, DGTQAN).
With PROFIBUS serial interface (DGTQPB).
With 16-bit analogue output 4-20mA / 0-5Vdc / 0-10Vdc at choice the maximum applicable voltage is 350 Ohm and the minimum applicable voltage resistance is 10 kohm (DGTQAN).
OPTIONS ONLY AVAILABLE AT TIME OF ORDER
Printer for weighing transmitter panel mounting
Time/Date
Alibi Memory
Expansion for a total of 6 relays
